The probe has been used outside of the recommended temperature range. The most common reasons for probe failures include: If this has happened, a new probe will resolve the issue. It is also possible the probe has failed. We would suggest replacing your ChefAlarm’s batteries, as a battery change typically fixes these types of symptoms. I purchased this ChefAlarm recently and although it worked well for a few months, it has now begun showing a “NO PROBE” error when the probe is clearly plugged in. Changing the battery usually solves this problem. When a battery’s charge starts to get low, sometimes there is enough charge left to power ChefAlarm on, but not enough to read a temperature. It did NOT say “No Probe and the low battery indicator wasn’t showing. I was able to turn it on and set alarm temperatures, but where it should have shown the current temperature, it was simply showing “-“. I was recently trying to use my ChefAlarm. If this does not work, please let our Tech Support team know. When a battery’s charge starts to get low, there is enough charge left to power ChefAlarm on, but not enough to read a temperature. ![]() If that does not work, we would suggest replacing your ChefAlarm’s batteries, as a battery change typically fixes these types of symptoms. The On/OFF switch is on the back of the unit. The display is still dark.įirst, make sure that you have turned your ChefAlarm on. I plugged the probe into my ChefAlarm and nothing happened. However, when it starts alarming, it pushes it past the threshold to a low battery status. We have found that when the battery is right on the edge of the voltage levels, it will have enough power to show the display. ![]() Other portions of the display are completely visible, though. I tried to use my ChefAlarm, but it won’t display a temperature. ![]() Any ideas what’s wrong? I tested all three probes with my DOT and all are functional. The ChefAlarm’s display reads “NO PROBE”. I tried to test my oven with my ChefAlarm and discovered that none of my Pro-Series probes are registering. This is done by pressing and holding the ON/OFF button on the back of the ChefAlarm for 3 seconds. However, we recommend turning the ChefAlarm off when not in use. Since it is a warning indicator, the flashing is normal. The “NO PROBE” is a notification to let you know that a probe is not plugged in. I have tried every button and nothing makes it stop flashing. Is the “NO PROBE” indicator suppose to constantly flash when ChefAlarm is not in use? I’m concerned that it will use up the battery when not necessary. if a “2” and a “4” appear, then the alarm was triggered on the sixth 3 hour segment of the trip, hour 15-18).Here are answers to the questions our Tech Support team is asked most often about the ChefAlarm. If more than one number flashes, the numbers should be added to determine the 3 hour segment of the day in which the alarm was triggered (e.g. After two seconds, the LCD will then flash numbers representing the three-hour window during which the alarm was triggered. ![]() if a “2” and a “4” appear, then the alarm was triggered on the sixth day of the trip). If more than one number flashes, the numbers should be added to determine the day on which the alarm was triggered (e.g. The LCD will clear, and the next number that appears indicates the day of the trip during which the alarm was triggered. if “2” flashes for four seconds, then Alarm 2 triggered first). The alarm that triggered first will flash on the LCD for four seconds (e.g. Press the Start button to determine which alarm triggered first (there are a maximum of four alarms that can trigger, depending on the unit’s programming). If there is an alarm activation symbol displayed on the TagAlert indicator, the AlarmAlert feature will provide information about the status of the first activated alarm which occurred within the first 10 days of trip. How do I read the AlarmAlert feature on the TagAlert indicator?
0 Comments
Leave a Reply. |